It's completely rounded out, which makes some sense. When I got the bike running a few weeks ago I tried to drive it in first gear, and it would only barely crawl. I was scared the whole transmission was blown, but now I'm surprised the bike moved at all. New sprocket is around $90. What makes it worse, is the previous owner drove on it and not only destroyed the sprocket but also chewed up the shaft it connects to.
![]() |
| Output Shafe |
So I went on eBay and got a whole used transmission, shifting linkage, and everything for only $30 shipped. Next we moved on to disassembling the rest of the engine so we could replace the gaskets and make sure everything else is in good working order. The gaskets needed some real TLC, due to the fact that their wasn't any. They used liquid gasket sealer and it got everywhere but where it should be.
After removing the clutch, we split the case and found something. (picture below)
We then spent the next hour or so figuring out where it went, looking at diagrams and examining all the parts, but we could not figure out where it went. We guessed that the old owner replaced something in the block that was broken and missed this little guy. Then, after figuring out how a manual transmission actually works (which I did figure out) I found where our mysterious piece came from.

This is where the shift lever connects to the transmission to shift into different gears. If you jam really hard down on the shifter, this is the piece you break I suppose. Here is another picture of it removed, it was broken is a few places and is one solid casting, luckily the transmission I bought comes with one.

That is about as far as we got this weekend, now just waiting for some parts and tools to come in so we can finish assembly. Below are some other pictures I took during the build.
![]() |
| Bottom view of the engine with the case split. |
![]() |
| Left side of the motor with clutch removed. |
![]() |
| Trying to keep the computer / repair manual clean.
Thank for reading, check back next week, should make good progress by then.
|





No comments:
Post a Comment