Hey everyone, and welcome to My KZ440D Mod Shop blog!
Last week I decided I wanted to find myself a new winter break project so I browsed Craigslist and found a perfect match, so I bought it. It's nothing special, just a Kawasaki KZ 440D. I'm pretty satisfied with what I got. The engine runs, suspension looks good, carbs cleaned, tires look great, new battery, no major rust on the frame and it comes with a bunch of extras. Including: a stock tank, a yamaha tank (for doing a cafe conversion), two yamaha seats (one is pretty bad, other is good), a brand new seat cover, all in one rear light/turnsignals, a set of front and rear LED turn signals, new petcock, service manual, 12 inch shorty exhaust pipes, and complete engine gasket kit. Not too bad for only $700, here's a few pics of the bike I got. (plenty more to come)

So far I have done a few things. First off, I removed the make-shift rear light holder. It was literally a bent piece of steel bolted on to the frame with two 10 led segment lights attached to it, with the most shady wiring. So now I have two extra lights I can use on the bike. Along with that, I started tackling the other wiring issues.
About the shady wiring, of the previous owners thought it would be a good idea to wire up part of the rear lights, but they didn't have a long enough piece of wire, so they attached on a 6 inch piece of green wire, to a black wire, no biggie. Then it was still too short, so they attached a red wire to the green wire, but that wire was still too short, then they attached another black segment. With that being said I am going to go through the entire electrical system and mend these errors.
After I got most of the rear wiring labeled and removed unnecessary wire, I started onto the tank. I was given two keys with the bike, one for the actual bike ignition, and another unknown key. Well the unknown key doesn't fit either tank or the helmet lock. Luckily the tanks were open already so I started on the original tanks lock. Took it apart and cleaned it, now it works perfectly, with any key too! Not that I want it to be open to anyone, but it's something that's not on the top of my to-do list. As for the rest of the tank, there was some light surface rust inside the tank, I could scrap some of it off with just my finger. For the time being, I tapped off the petcock opening and put some paint thinner inside to prevent any more rusting.
This weekend I am planning on putting the tank on, getting her fired up and going for a little test drive. If that checks out, I'm going to pull the heads and replace the gasket that is leaking. If I still have some time left over, I'll start tearing into the front end wiring.

No comments:
Post a Comment